Install the Client Software using the Command Line
Install the client software using the Windows command prompt
You can use the Windows command prompt to install the client software on a standalone or endpoint computer.
- Create the following folder if it doesn't exist:
C:\Windows\Temp\SkyhighLogs\ - Open an Administrator Command Prompt.
- Copy and paste one of these commands at the prompt, then click Enter.
- 32-bit installation — SCPInstaller.x86.msi REBOOT=ReallySuppress /q /L*V+ "C:\Windows \Temp\SkyhighLogs\SCPInstall.log"
- 64-bit installation — SCPInstaller.x64.msi REBOOT=ReallySuppress /q /L*V+ "C:\Windows \Temp\SkyhighLogs\SCPInstall.log"
NOTE: The system reboot is suppressed at the end of the installation when you specify REBOOT=ReallySuppress. To force the system to reboot, use SCPInstaller.x86.msi REBOOT=Force /q /L*V+ "C:\Windows\Temp \SkyhighLogs\SCPInstall.log"
The client software is installed on a Windows-based computer.
Install the client software using the Mac Terminal
You can use the Mac Terminal to install the client software on a standalone or endpoint computer.
- Open the Mac Terminal.
- Navigate to the folder containing the Client Proxy installation package: ScpDistribution.pkg.
- To create a subfolder for logging the installation, enter this command:
mkdir log_folder
- In the same directory as the installation package, enter this command:
sudo installer -verbose -dumplog -pkg ScpDistribution.pkg -target / > log_folder/scp_install.log 2>&1
The client software is installed on the macOS computer.