Skip to main content

Check out Interactive Visual Stories to gain hands-on experience with the SSE product features. Click here.

Skyhigh Security

Back Panel and Port Assignments

The following diagrams show the port assignments on the older appliance models.

These models include the WBG-4500-C, WBG-5000-C, and WBG-5500-C appliances.

 

WBG-4500-C

This appliance model has two onboard network interfaces in the middle of its rear panel.

Two more network interfaces are made available on a network interface card, which is installed in the card slot on the right.

wbg-4500-c.png

The network interfaces provide ports, which the operating system assigns names to as follows:

Position Interface Name assigned to port on interface
1 Network interface 1 eth0
2 Network interface 2 eth1
3 Network interface 3 eth2
4 Network interface 4 eth3

 

WBG-5000-C

This appliance model has four onboard network interfaces in the middle of its rear panel and an RMM interface on the right.

Four more network interfaces can be added on a network interface card that is installed in the card slot on the right. This will increase the number of network interfaces to eight. You must purchase this card on your own and install it.

wbg-5000-c.png

The network interfaces provide ports, which the operating system assigns names to as follows:

Position Interface Name assigned to port on interface
1 Network interface 1 eth0
2 Network interface 2 eth1
3 Network interface 3 eth2
4 Network interface 4 eth3
5

RMM

For operating the Remote Management Module (RMM) with Baseboard Management Controller (BMC)

 

 

WBG-5500-C

This appliance model has four onboard network interfaces in the middle of its rear panel and an RMM interface on the right.

Four more network interfaces can be added on a network interface card that is installed in a card slot on the panel. This will increase the number of network interfaces to eight. You must purchase this card on your own and install it.

wbg-5500-c.png

The network interfaces provide ports, which the operating system assigns names to as follows:

Position Interface Name assigned to port on interface
1 Network interface 1 eth0
2 Network interface 2 eth1
3 Network interface 3 eth2
4 Network interface 4 eth3
5

RMM

For operating the Remote Management Module (RMM) with (Baseboard Management Controller (BMC)

 

 

See also

Add a module card

 

  • Was this article helpful?