Skip to main content

Check out Interactive Visual Stories to gain hands-on experience with the SSE product features. Click here.

Skyhigh Security

Install a Module Card

To install a module card on a physical Web Gateway appliance, where the appliance software runs on a hardware platform, you unplug the appliance, remove its cover, and insert the card in a suitable slot.

IMPORTANT: To avoid damage to the appliance or the module card caused by electrostatic discharge (ESD), make sure that you work in an ESD-protected area.

  1. Turn off the appliance and unplug the power cord.
    NOTE: Turn off and unplug the appliance before removing its cover. Failure to do so could endanger you and damage the appliance or the module card.
  2. Remove the appliance cover.
  3. Insert the module card.
    NOTE: Some appliance models secure the module card with a screw, others use retention clips.
    1. Remove the card riser assembly.
    2. If retention clips are used, open the front and rear clips on the assembly.
    3. Choose a slot on the assembly for inserting the module card and remove the filler panel from this slot.
      NOTE: On model WBG-5500-C, you must use riser slot 2.
    4. If a securing screw is used, remove it.
    5. Push the module card into the slot until it seats in the card connector.
      NOTE: Use caution when pushing the card, as excessive force can break the connector.
    6. Secure the module card with the screw or close the front and rear retention clips.
    7. Reinstall the assembly.
  4. Reattach the appliance cover and plug in the power cord.
  5. Turn on the appliance.
  • Was this article helpful?